Side milling cutters
Article no. CH-50052150
-
- This profile bar milling cutter is straight toothed.
- The form relief is ground with an axial and radial relief angle of 0°.
- Thus, the flute can be resharpend without changing the form.
- The accuracy of the form are around +/- 0.015mm.
- This option demands item no. CH-50052150 (Form cutters).
-
- This side-milling cutter is helical-toothed with a right and a left hand helix.
- The tip side edges in front and at rear can be produced in one course.
- This option demands item no. CH-50052150 (Form cutters).
-
- This profile side-and face-milling cutter is straight toothed.
- The form is copied with a point wheel.
- This option demands item no. CH-50052150 (Form cutters).