Tool measurement

back to list
  • CH-50052110 - Automatic tool measurement using a probe

    • For milling cutters, drills/step drills and form cutters.
      In the machines, different geometrical values can be measured with the help of a probe, depending on the tool type. (The following list is not complete):
      - Clamping length, radial view direction, division, position of coolant hole
      - Diameter, lead, taper angle, taper, cutting edge length, flute depth
      - Shear angle, chamfer angle, side distance
      - Run-out error
    • This option needs a single customized adaptation to the installed measurement procedure.
    • The possibilities are dependent from the form of the used probe.
  • CH-50052190 - Automatic wheel measurement using a probe

    • For form and cup wheels: diameter and flange dimension.
    • For peripheral wheels: diameter, flange dimension, width and angle.
    • This option needs a single customized adaptation to the installed measurement procedure.
  • CH-50052690 - Extension for in-process measurement

    • Measurement of ground diameter immediately after the according operation is finished.
      Available for several operations. Detailed information upon request.
    • After measurement automatic compensation and repetition of the operation if needed.
    • Requires a probe with a cylindrical shank which allows to probe the diameter from above and below the tool.
    • This option demands item no. CH-50052110 (Measuring tools). Additional item no. CH-50052230 (NUMROTOControl / Loader) is recommended.