• Sheet drill

    • This so called sheet drill is ground with a shear angle.    
    • It is clearly visible that the flute drifts away from the center alongside the tool axis.    
    • The steps at the periphery are generally ground cylindrically in advance.    
    • This option demands item no. CH-50052150 (Form cutters).
  • Flow drill

    • This tool is programmed with a polygon modification at the periphery.    
    • This option demands item no. CH-50052150 (Form cutters) and additionally item  no. CH-50052480 (Special grinding functions).
  • Clutch

    • This work piece has been completely programmed with the component 'manual grinding path'.
    • For this tool, an extension is needed,  in which the component 'manual grinding path' is available. There is a choice between no. CH-50052150 (Form cutters), CH-50052360 (Complex milling cutters) and CH-50052380 (Complex drills).
  • Clutch gear

    • This work piece has been completely programmed with the component 'manual grinding path'.
    • This option demands item no. CH-50052150 (Form cutters).
  • Prope point

    • This probe point has been completely programmed with the component 'manual grinding path'.
    • For this tool, an extension is needed, in which the component 'manual grinding path' is available.There is a choice between no. CH-50052150 (Form cutters), CH-50052360 (Complex milling cutters) and CH-50052380 (Complex drills).
  • Paper cut tool

    • This tool has been completely programmed with the component 'manual grinding path'.    
    • For this tool, an extension is needed, in which the component 'manual grinding path' is available.There is a choice between no. CH-50052150 (Form cutters), CH-50052360 (Complex milling cutters) and CH-50052380 (Complex drills).
  • Insert fitting

    • Example for the grinding of an insert fitting at the side of the periphery.    
    • The fittings are ground with a high frequency spindle and a fitting burr.    
    • For this tool, no CH-50052480 (Special grindig functions) is needed, in which the component 'manual profile grinding path' is available. There is a choice between no. CH-50052150 (Form cutters), CH-50052360 (Complex milling cutters) and CH-50052380 (Complex drills).
  • Punch

    • This punch has been completely programmed with the component 'manual grinding path'.    
    • This option demands item no. CH-50052150 (Form cutters).
  • Step drill with ballnose tip

    • For this tool, a step drill (with DXF form step) is combined with a cutter (ballnose tip).    
    • This option demands item no. CH-50052380 (Complex drills), CH-50052080 (Extension for form steps) and CH-50052350 (Simple milling cutters).
  • Torx

    • Special tool with form on tip side.    
    • This option demands item no. CH-50052150 (Form cutters) and No. CH-50052450 (Clamping system transformation).
  • Basic polygon

    • Deep cut of a basic polygon.
      - Grinding of cam disk.
      - Eccentric forms for turning tools.    
    • This option demands item no. CH-50052150 (Form cutters) and CH-50052450 (Clamping system transformation).
  • Ceramic knife

    • Form grinding with radial infeed.    
    • This option demands item no. CH-50052150 (Form cutters) and CH-50052450 (Clamping system transformation).