Profile inserts

Article no. CH-50052150

back to list
  • Profile insert

    • This profile insert is clamped into a holder.    
    • The relief angle of the insert behaves only axial in the front area, at the periphery, however, axial and radial.    
    • Therefore, the insert can be used for both directions.    
    • This option demands item no. CH-50052150 (Form cutters).
  • Trapeziodal insert

    • This profile insert is clamped in a rotating holder.    
    • The relief angle of the insert behaves axial in the front area, at the periphery, however, axial and radial.    
    • Avoidance the hollow grinding due the 3-axis oscillation.    
    • This option demands item no. CH-50052150 (Form cutters) and no. CH-50052760 (3-axis oscillation for form relief grinding).
  • Indexable insert

    • Indexable insert ground in one set-up.    
    • Constant radii along the form.    
    • This option demands item no. CH-50052150 (Form cutters) and CH-50052450 (Clamping system transformation).
  • Drilling insert

    • Drilling insert ground in one set-up.    
    • Therefore, the insert can be used for both directions.    
    • This option demands item no. CH-50052150 (Form cutters) and CH-50052450 (Clamping system transformation).
  • Full radius insert

    • This Radius insert is clamped in a rotating holder.    
    • The radius and k-land is produced in one pass.    
    • This option demands item no. CH-50052150 (Form cutters).